I recently had my power supply replaced on my Dell Desktop computer (because I fried the old one) and now when I boot it up it prompts me to press f1 to continue or f2 to enter setup utility. So I press f2, because f1 leads to nowhere, and it takes me to the BIOS screen. But from here I am lost, I don't know what to change and what not to in order to correct the issue. Thoughts?|||well you have some hardware installation problem or loose installation of RAM or Battery(Lithium Cell). If it showing same then must hire any hardware expert.|||Ok, thanks for the help. I will have it looked at by the shop which repaired it.
Report Abuse
|||Most likely whoever replaced your power supply forgot to reconnect the molex or sata power connector to your harddrive. With no harddrive and thus no Operating System, pressing f1 would lead you nowhere.
I would take it back to the shop that did the repair and have them look at it unless you are comfortable taking the side panel off and checking the wires.
http://h20000.www2.hp.com/bc/docs/suppor鈥?/a>
Good Luck.
No comments:
Post a Comment